Base cored solder wire

I made a base for cored solder wire .

Here it is some from the material,where i will use,piece of woods,screws,washers, e.t.c	Here i cut two pieces of wood 10 cm x 8 cm	Here i connected two pieces of woods,with two angle brackets with four screws for woods.


Here i put at center of wood one screw 7 cm lenght and 6 mm diameter,and at small wood i put a driver for the ent side the cuore solder wire .	Here i cut a small piece tube ö 16 and i will pass at center of solder wire ,for it is more stable when it around over to screw.	Here i put at center of hole of solder wire,the plastic tube Ö 16.


Here i stick with warm glue the small piece of wood for driver at straight line the solder wire .	And from the other side .	Here i put from down side 4 little sponge


Here i will put white tape all arround to wood ,with synthetic rubber adhesive .	Here i cut the tape at same dimension for to stick to the wood .	Here it is ready


	Click here for you see a video